Renogy inverter

[catterpie99]

I set up a Renogy inverter with 6 panels and a 120V system. DC and AC sides are both live, but the inverter won't start. All switches are on and wiring matches the guide. Any ideas on what could be wrong?

 

[HighVoltageGuy]

It can be a lot of things, so let's start with the most obvious one, the voltage. If the voltage from the panels doesn't match the DC input then t inverter won't start. While you're at it, you could also check the polarity of each one and make sure they're all right.

 

[Chambers_90]

From what I know, if both sides are live but the inverter won't start, check the battery voltage with a multimeter, Renogy inverters need at least 11V to kick on. Also look for any fault lights or alarms that might mean it's in protection mode. Sometimes a loose ground or low battery can trip it even if everything looks good.

 

[Ilove_theearth]

Most Renogy inverters won't start unless the battery voltage is within the required range, check your battery bank. Also, some models need a DC switch or remote switch to be closed even if the main switches are on